DESIGN AND FABRICATION OF VTOL DRONE
A dual propelled Vertical Take-Off and Landing Drone is modeled using the software SOLIDWORKS. This modeled drone is fabricated by the means of general conventional methods of fabrication and Additive manufacturing technique.
Design of the VTOL Drone
1) Body
2) Wing
c) Tail
d) Wing Support
e) Motor Holder
f) Shaft Holder
g) Gear
Final Design
Fabricated Drone
Materials Used
1) Body, Wing & Tail - Depron Foam board
2) Frame - Hollow Aluminium Bars
3) Wing Supports, Gears, Motor & Shaft holders - PLA
Components Used
1) 1045 Propellers
2) LiPo 3s Battery
3) A2212 13T BLDC Motor
4) Standard 30A BLDC Electronic Speed Controller
5) MG90S Micro Servos
6) KK2 1.5 Multi Rotor LCD Flight Controller
7) CT6B Remote 6 Channel Transmitter & Receiver
Remarks
1) The shape of the body,wing and the tail has been altered due to technical issues.
